Squaringthe Saw Bladeto The Fence - COMPANION 315.241940 Operator's Manual

SQUARINGTHE SAW BLADETO THE FENCE
See Figures 17 - 20.
• Unplug your saw.
•Pu[[ the saw arm a[I the way down and engage the lock
p_nto hold the saw arm in transport position.
• Loosen the miter lock Ievere.
• Ro_ztethe miter table unti[the pointer is positioned
at0".
• Securely tighten _le miter [ook levers.
• Lay a framing square fiat on the miter table. Place one
leg of the square against the fence. Slide the other leg
of the square against the fiat paTtof saw blade.
NOTE: Make sure that the square contacts the fiat pert
of the saw blade, not the blade teeth.
• The edge of the square and the saw blade should be
parallelas shown in figure 17.
• If the front or back edge of the saw blade angles away
from the square as shown in figures 18 and 19, adjust-
merits are needed.
• Using a 14 mm wrench, loosen the hex screws that
secure the mounting bracket to the miter table.
• Rotate the mounting bracket lei_t or right untilthe saw
blade Lspara.[[e( w }th the squaze,
• RatJghtenthe screwssacure[y and recheck the b[ade-
to-fence alignment.
FENCE
FENCE
BASE
FENCE
BASE
FRAMING
SQUARE
VIEWOFBLADE NOTSQUARE W ITH
FENP..,E, ADJUSTMENTS APEREQUIRED
FRAMING
SQUARE
VIEWOFBLADE NOTSQUARE WITH
FENCE, A DJUSTMENTS AREREQUIRED
Fig. 18
BLADE
F_.lg
BASE
FRAMING
SQUARE
VIEWOFBLADE
SQUARE WITH FENCE
Fig. 17
HEXHEAD
MOUNTING
BRACKET
MI'I'ER
TABLE
Fig. 20
18