Operating Instructions Automatic Icemaker - GE GSC23LGRDBB Owner's Manual And Installation

About the automatic icemaker, ge.com
A newly installed refrigerator may take 12 to 24 hours to begin making ice.
Automatic Icemaker
Icemaker
!
i i
Power Switch _rArm
The icemaker will produce seven cubes
pet cycle--approximately 100-130 cubes
in a 24-hour period, depending on fleezer
compamnent temperature, room
mmperantre, number of door openings
and other use conditions.
See below for how to access ice and reach
the power switch on dispenser models.
If the refligerator is operated before the
water connection is made to the icemakeh
set the power switch in the OFFposition.
X_qlen the refligemtor has been connected
to the water suppl); set the power switch to
the 0N position.
The icemaker will fill wifll water when it
cools m 15°F (-10°C). A newly installed
refl-igetamr m W take 12 m 24 hom_ m begin
making ice cubes.
You will hear a buzzing sound each time
the icemaker fills with water.
Throw away the first few batches of ice to
allow the water line to cleat.
Be sure nothing interferes with the sweep
of the feeler arm.
When file bin fills m file level of file feeler
arm, file icemaker will stop producing
ice. It is normal for several cubes m be
joined together.
If ice is not used flequently, old ice cubes
will become cloudy, tasm stale and shrink.
Models without a shelf
above the ice bin
Toaccessiceandreach the
icemakerpower switch:
o Lift the bin, then pull it
forward until the bin stops.
o ower the bin to access ice
or reach the power switch.
NOTE:In order to take full advantage
of the tilt-out ice bin, only store items
on the shelf below the ice bin that
are no rafter than the Iowest point
on the bin.
Accessing Ice and Reaching the
Power Switch on Dispenser Models
There are two types of ice storage bins on
dispenser models. One has a shelf above
the bin, the other does not.
Special note about dispenser models
without a shelf above the ice bin:
These models have a tilt-out ice bin.
The bin can be tilted out as shown in
the illustrations, and it will hold itself
tap while you take ice out or turn the
icemaker power switch on and off:
Be sure m put the bin back in place
before closing the dooL
Models with a shelf
above the ice bin
/
Toaccessice, pullthe binforward.
iiiiii_
Tobucket restore your theice level from an empty
stage, following steps are
recommended:
A
12 horns after the first batch of ice
has fallen into the bin, dispense
3 to 4 cubes.
AtYer an additional 6 horns, dispense
3 to 4 cubes again.
To reach the power switch, pull the
shelf straight out. Always be sure to
replace the shelf.
These steps will restore your ice level
in the shortest amount of time.
11