Operating Instructions Automatic Icemaker - GE 197D3351P003 Owner's Manual And Installation Instructions

About crisper removal.
Not all features are on all models.
Crisper
Guides
When replacing the crispers, make
sure you slide them through the
crisper guides.
About the automatic icemaker.
A newly-installed refrigerator may take 12–24 hours to begin making ice.
Power
Switch
Icemaker
Green
Power Light Feeler Arm
Crisper Removal
Crispers can easily be removed by tilting up
slightly and pulling past stop location.
Automatic Icemaker
(on some models)
The icemaker will produce seven cubes
per cycle—approximately 100–130 cubes
in a 24-hour period, depending on freezer
compartment temperature, room
temperature, number of door openings
and other use conditions.
If the refrigerator is operated before the
water connection is made to the icemaker,
set the power switch in the O (off) position.
When the refrigerator has been connected
to the water supply, set the power switch to
the l (on) position.
The icemaker will fill with water when it
cools to 15°F. A newly-installed refrigerator
may take 12 to 24 hours to begin making
ice cubes.
Throw away the first few batches of ice to
allow the water line to clear.
Be sure nothing interferes with the sweep
of the feeler arm.
It is normal for several cubes to be joined
together.
Ice Storage Drawer
To access ice, pull the drawer out.
Icemaker Accessory Kit
If your refrigerator did not come already
equipped with an automatic icemaker,
an icemaker accessory kit is available at
extra cost.
www.GEAppliances.com
If the door prevents you from taking out
the crispers, the refrigerator will need to
be rolled forward until the door opens
enough to slide the crispers out. In some
cases, when you roll the refrigerator out,
you will need to move the refrigerator to
the left as you roll it out.
If ice is not used frequently, old ice cubes
will become cloudy, taste stale and shrink.
If ice cubes get stuck in the icemaker,the
green power light will blink. To correct this,
set the power switch to O (off) and remove
the cubes. Set the power switch to l (on) to
restart the icemaker. After the icemaker has
been turned on again, there will be a delay
of about 45 minutes before the icemaker
resumes operation.
NOTE: In homes with lower-than-average water
pressure, you may hear the icemaker cycle multiple
times when making one batch of ice.
There is an upper freezer shelf
above the icemaker that can be
used for storage.
To remove the drawer, pull it straight out
and lift it past the stop location.
Check the back of the refrigerator for
the specific icemaker kit needed for
your model.
9