Ai Editrecording - Aiwa CX-NA50 Operating Instructions Manual

AI EDITRECORDING
4
s .....
= : .:: =
C3_
_
-- 0-9,+10
_QC
The AI edit function enables CD recordingwithoutworrying about
tape length and track length. When a CD is inserted, the unit
automatically calculates the total track length. If necessary, the
order of tracks is rearranged so that no track is cut short.
(AI: Artificial Intelligence)
6 Press the • REC/REC MUTE button to start
recording.
The tape is rewound to the beginning of the front side, the
lead segment is playedthroughfor 10 seconds, and recording
starts. When recording on the front (side A) ends, recording
on the back (side B) starts.
To stop recording
Press the • button. Recording and CD play stop simultaneously.
To clear the edit program
Press the • CLEAR button twice so that "EDIT" disappears on
the display.
To check the order of the programmed track numbers
Before recording, press the CD EDIT/CH ECK to select side A or
B, and press the <t<1 or _ button repeatedly,
Programmed
Track number track numbers
AI edit recording will not start from a point halfway into the tape.
The tape must be recorded from the beginning of either side.
1 Insert the tape into deck 2.
Insert the tape with the side to be recorded on first _ec{ng out
from the unit.
2 Press the CD button and load the disc(s).
3 Press the CD EDIT/CHECK button once,
"EDIT" and "AI" lights up on thedisplay.
AI EDIT
Each time it is pressed, the display changes as follows.
_ A] EDIT _ PRGM EDIT - I
To select with the remote control, press the EDIT/CHECK
button while pressing the SHIFT button.
4 Press one of the DISC DIRECT PLAY buttons to
select a disc,
5 Press the <i<1 or _ button to designate the
tape length.
10 to 99 minutes can be specified.
Ina few seconds, the microcomputer determines the tracks
to be recorded on each side of the tape.
• The numbered buttons on the remote control are also
available to designate the '_.pe length.
Example: When using a 60-minute tape, press the 6 and 0
buttons.
Tape side A Selected
Tape length (front side) tracks for side A
Remaining time of side A
Program number
To add tracks from other discs to the edit program
If there is any time remaining on the tape after step 5, you can
add tracks from other discs in the CD compartment.
1 Press the CD EDIT/CHECK button to select side A or B.
2 Press one of the DISC DIRECT PLAY buttons to select a disc.
3 Press the numbered buttons on the remote control to select
tracks. "PRGM" appears on the display.
A track whose playing time is longer than the remaining time
cannot be programmed.
4 Repeat steps 2 and 3 to add more tracks.
Time on cassette tapes and editing time
The actual c_ssette recording time is usually a little longer than
the specified recording time printed on the label. This unit can
program tracks to use the extra time. When the total recording
time is a little longer than the tape's specified recording time
after editing, the display shows the extra time (without a minus
mark), instead of the time remaining on the tape (with the minus
mark).
• Recording is inhibited if the erasure prevention tab on either
side of the tape is broken off.
• The AI edit function cannot be used with discs containing 31
tracks or more.