Sharp Plasmacluster FP-N60CX Operation Manual page 13

PREPARATION
2
Filter Installation
1
After the True HEPA Filter is removed
from the plastic bag, place it within the
Filter Frame with the tabs facing up.
Do not install the filter backwards or the unit will
not operate properly.
2
After removing the Washable Active
Carbon Filter from the plastic bag,
place it within the Filter Frame on top
of the True HEPA Filter.
3
Next, place the Filter Separator and
then the Pre-Filter within the Filter
Frame.
• Place the Filter Separator so that
the ribs are facing down.
• Insert the tabs of the Pre-Filter
into the associated holes found
on the Filter Frame.
• Mount the Filter Frame as shown
in the diagram to the right to the
main unit.
4
Fill in the usage start date on the Date
Label, which can be found on upper left
corner of the Main unit. Mount the Front
Panel to the Main Unit.
Use the date as a guide for the
Filter Replacement schedule.
Battery Information
• The batteries for this remote control are for initial use only . Change the batteries when necessary.
• Incorrect usage of the batteries may cause battery fluid leakage and/or damage.
Take care of the following when handling:
• When replacing the batteries, replace both batteries with new ones of the same type. (Use 2 AA
manganese batteries.)
• When not using the unit or remote control for an extended period, remove the batteries.
• The batteries are for initial use only and may be depleted within 1 year.
True HEPA Filter
Filter Frame
Washable Active
Carbon Filter
True HEPA Filter
Filter Frame
Rib of the Filter Separator
Filter Separator
Washable Active
Carbon Filter
Filter Frame
Filter Frame
Date Label
E-11
Tabs
Tabs (4 places)
Pre-Filter
Holes