Troubleshooting - Sharp Plasmacluster IG-A20U Operation Manual

TROUBLESHOOTING

Before calling for service, please review the TROUBLESHOOTING chart below.
Since the problem may not be a unit malfunction.
Problem
The Plasmacluster Ion Generator does
not work.
fl ashing faster (red)
fl ashing (red) fl ashing (blue)
The discharged air has odor.
A clicking or ticking sound comes from the
unit while operating the Plasmacluster Ion
Generator.
Lighting (yellow)
A discontinuous noise is heard.
The air fl ow decreases.
Make sure the unit is plugged in.
Approx 2 months(Approx. 1,500 hours)
has passed since Plasmacluster Ion's
replacement time.
Replace with a new Plasmacluster Ion
Generating Unit. See page E-12,13,14.
If all lights keep fl ashing, contact the store
you purchased or Sharp Service Center.
Plasmacluster ions are not released.
• Clean the electrode section of the units.
(See page E-11.)
• Dust may block the fi lter, clean the fi lter.
Unplug the unit, wait 10 seconds, then plug
fl ashing (blue)
the unit back in and restart. If the unit still
does not operate, contact the store you
purchased or Sharp Service Center.
fl ashing (blue)
The Plasmacluster Ion Generator releases
a small trace of ozone which may produce
odor. This is well below acceptable limits.
A clicking or ticking sound comes from the
Plasmacluster Ion Generating Unit. Loudness
can be changed depending on a room humidity,
but the effectiveness is the same. Relocate the
Plasmacluster Ion Generator if necessary.
Filter cleaning time. See page E-10. After
cleaning the filter, press FILTER RESET
Button for 3 seconds.
Filter is getting dirty.
Clean the fi lter.
After cleaning the filter, press FILTER
RESET Button for 3 seconds.
E-16
WHAT TO DO