Table of Contents
Advertisement
EXPOSURE
ZOOM POS INIT
LENS INIT
END
BRIGHTNESS
IRIS
SHUTTER
AGC
SSNR
SENS-UP
END
Defines a zoom position after powering up the camera,
range is x1 ~ x10
Reset of the autofocus lens in case of malfunction
Return to CAMERA ADVANCED SETTING page
Image brightness setting, range 1~100
Mode of the lens iris:
AUTO:
automatic iris mode
MANUAL:
manual iris operation
Electronic exposure control
ESC:
Electronic auto shutter, the shutter speed is
automatically adapted to light conditions
NOTE: This mode item is only available for setup
if IRIS mode is set to "MANUAL"
MANUAL: Manual setup of shutter speed
A.FLK: Flickerless mode. Useful in sceneries with light
sources powered with a frequency different
from the camera
Automatic Gain Control, gains video signal under low light
conditions.
HIGH: AGC ON, high gain
NORMAL: AGC ON, normal gain
OFF: AGC off (SSNR and SENS-UP are not available in
this mode)
Signal noise reduction. This feature improves the signal-
noise ratio under low-light conditions.
OFF: no noise reduction
LOW, MID, HIGH: level of noise reduction
NOTE: this feature requires setting AGC: NORMAL or
HIGH
The SENS-UP function increases the light sensitivity by
interpolation of several images.
AUTO: SENS-UP function active. Enter the submenu to
enter the number of maximum interpolated
pictures (2 ~ 128)
NOTE: Please consider that a higher value
creates brighter pictures, but due to the
longer calculation time moving objects
may appear distorted in the picture.
(effect similar to longer exposure time at
photo cameras)
OFF: no SENS-UP function
NOTE: this feature requires setting AGC: NORMAL or
HIGH
Return to CAMERA ADVANCED SETTING page
29
EPTZ100_ma_en_rev03.doc
Advertisement
Table of Contents
