Engine Block Heater - If Equipped; Automatic Transaxle - Chrysler Sebring Convertible Owner's Manual

ENGINE BLOCK HEATER — IF EQUIPPED
The engine block heater warms engine coolant and
permits quicker starts in cold weather. Connect the cord
to a standard 110-115 volt AC electrical outlet with a
grounded, three-wire extension cord.
The engine block heater cord is bundled under the hood
between the headlight assembly and the Totally Inte-
grated Power Module (Fuse Box) on the driver side of the
vehicle.
WARNING!
Remember to disconnect the cord before driving.
Damage to the 110-115 volt electrical cord could cause
electrocution.

AUTOMATIC TRANSAXLE

CAUTION!
Damage to the transaxle may occur if the following
precautions are not observed:
• Shift the gear selector lever into PARK only after
the vehicle has come to a complete stop.
• Shift the gear selector lever into or out of RE-
VERSE only after the vehicle has come to a com-
plete stop and the engine is at idle speed.
• Do not shift the gear selector lever from RE-
VERSE, PARK, or NEUTRAL into any forward
gear when the engine is above idle speed.
• Before shifting the gear selector lever into any gear,
make sure your foot is firmly on the brake pedal.
NOTE: You MUST press and hold the brake pedal down
while shifting the gear selector lever out of PARK.
STARTING AND OPERATING 255
5