Radial Ply Tires - Chrysler Sebring Coupe Owner's Manual

door.
The recommended inflation pressures should be followed
when the specified tires are installed.
Item Tire size
Normal tire P205/60R16 91H
P215/50R17 90H
Compact spare tire T125/70D16
The pressures should be checked and adjusted, if neces-
sary, at least once a month.
Tire pressures should be checked more often when weather
temperatures vary widely, because tire pressures vary with
outdoor temperatures. Inflation pressures specified on the
placard are always "cold inflation pressure".
Cold inflation pressure can be measured after the vehicle
has been stationary for at least three hours or driven less
than one mile (1.6 km) after being stationary for three
hours.
Cold inflation pressure must not exceed the maximum
values molded into the tire sidewall. After driving sev-
eral miles, tire inflation pressure may increase 2 to 6 psi
(14 to 41 kPa) over the cold inflation pressure; do NOT let
air out of the tires to match the specified cold pressure, or
your tires will be underinflated.
Check your tires each time you refuel. If one tire looks
lower than the others, check the tire inflation pressure for
Front Rear all of them. The following precautions also should be
observed:
32 psi (220 kpa)
32 psi (220 kpa)
1. Keep your tires inflated to the pressures that are
60 psi (420 kpa)
recommended. (See the tire and loading information
placard attached on the latch on the driver's door.)
2. Stay within the load limits that are recommended.
3. Make sure that the weight of your vehicle load is
evenly distributed.
4. Drive at safe speeds.
5. After the tire inflation pressure has been adjusted,
check the tires for damage and air leaks. Be sure to
replace the rubber caps on the valve stems.

Radial ply tires

Radial ply tires provide improved tread life, road hazard
resistance and smoother high speed ride. The radial ply
MAINTENANCE 337
9