Universal tilt wall mount for lcd and plasma 32" - 56" (81 - 142 cm) flat panel screens (38 pages)
Summary of Contents for PEERLESS HLG452-002
Page 1
Installation and Assembly Flat-Panel Base Lock-Down Kit For Philips Display Models Models: HLG452-002, HLG452-002-Q10 Maximum Display Weight: 100 lb (45.35 kg) 3215 W. North Ave. • Melrose Park, IL 60160 • (800) 729-0307 or (708) 865-8870 • Fax: (708) 865-2941 • www.peerlessmounts.com ISSUED: 09-04-08 SHEET #: 090-9150-3 10-05-09...
NOTE: Read instruction sheet before you start installation and assembly. Parts may appear slightly different than illustrated. Before you begin, make sure all parts shown are included with your product. Parts List HLG452-002 HLG452-002-Q10 Description Qty. Part # Qty. Part # A lock-down plate 1 090-1757 090-1757...
Page 3
Installation Option 1 (Fasteners) DISPLAY MODEL HOLE PATTERNS SBP240M/27 42HF7945D/27 26HFL5830D/27 37HFL5560D/27 32HFL5460D/27 42HFL55860D/27 32HFL5860D/27 42HFL7945D/27 32HFL7560D/27 42HFL7580A/27 32HF7965D/27 52HFL5580D/27 32HFL7965D/27 SCREWS SUPPLIED BY DISPLAY MANUFACTURER SCREWS SUPPLIED BY DISPLAY SCREWS SUPPLIED BY DISPLAY MANUFACTURER MANUFACTURER Use lock-down plate (A) as a template to mark location Slide two 1/4-20 x 1 3/4"...
Page 4
Attach lock-down plate to display base bottom using Hand tighten slope nut (D) through 1/4-20 x 1 3/4" screws provided by manufacturer. Refer to page three screw bolt (B) until snug against bottom of desktop for lock-down plate/ display base stand hole pattern. surface.
Page 5
Installation Option 2 (Adhesive Strips) DISPLAY MODEL HOLE PATTERNS Attach lock-down plate to display base bottom using SBP240M/27 screws provided by manufacturer. Refer to lock-down plate/ display base stand hole pattern. NOTE: Remove existing rubber feet from display base that interfere with the lock-down plate. 42HF7945D/27 HOLE PATTERN SHOWN SCREWS SUPPLIED BY DISPLAY MANUFACTURER...
Page 6
Clean bottom of lock-down plate (A) with rubbing alcohol. Spray bottom of lock-down plate (A) only where tape will be applied, with 3M rubber and vinyl #80 spray adhesive. Pull apart the four adhesive strips (E) and remove red backing film on both sides. Wait at least 4 minutes to dry before applying adhesive strip (E).