Security; Telnet Tcp Port; Legal Ip Address Pool - Patton electronics COPPERLINK 2160 Series User Manual

Model 2160 Series User Manual
There are two UI modes for setting up the Model 2160, command and menu mode. The menu mode uses a
menu-driven interface. The command mode uses line commands. (Command mode is not covered in this
manual).
Move the cursor " >>" to profile in the modify menu and press Enter.
-----------------------------------------------------------------------------
Command: admin user modify 2 profile <name> <pass_conf>
Message: Please input the following information.
Legal user name (ENTER for default) <test>:
Input the old Access password: ****
Input the new Access password: ****
Re-type Access password: *****
-----------------------------------------------------------------------------
Enter the user name and set up the new access password. You must enter the new assess password twice for
confirmation.
Use the list command to view information for each user profile, including user name and UI mode.

Security

The security command menu lists commands to configure sixteen legal IP addresses for Telnet access and the
Telnet port number. Move the cursor " >>" to security in the admin menu and press Enter. The following
menu displays:
>> port Configure telnet TCP port
ip_pool

Legal IP address pool

list Show security profile

Telnet TCP Port

To set up the Telnet TCP port, move the cursor " >>" to port in the security menu and press Enter. You can
select a port number from 1 to 65534. The default number is 23.
-----------------------------------------------------------------------------
Command: admin security port <1~65534>
Message: Please input the following information.
Telnet Listening TCP Port (ENTER for default) <23>:
-----------------------------------------------------------------------------

Legal IP Address Pool

The default legal address is 0.0.0.0. (on entry number 1). This means that there are no IP address restrictions
for accessing the MOdel 2160 via Telnet. To change the legal IP address pool, move the cursor " >>" to
ip_pool in the security menu and press Enter. Select modify to set up the IP address pool.
Administration Command Menu
5 • Console and Telnet configuration
96