Table of Contents
Advertisement
TG7100-7120E(e).book Page 9 Tuesday, July 4, 2006 3:29 PM
Connections
Base unit
When connecting the AC adaptor to the
base unit, a short beep will be heard. If it is
not heard, check the connections.
(220–240 V, 50 Hz)
To telephone
network
Use only the included AC
adaptor and telephone
line cord.
Charger (KX-TG7102, KX-TG7103, KX-
TG7122, and KX-TG7123 only)
Connect the AC adaptor to the charger and
route the cable as shown. The charger can
be mounted on the wall, if required.
Hooks
25 mm
Screws
Use only the included AC adaptor.
Note:
L Never install telephone wiring during a
lightning storm.
L The AC adaptor must remain connected
at all times. (It is normal for the adaptor to
feel warm during use.)
Helpline Tel. No.: U.K. 08700 100 076 R.O.I. 01289 8333
L The AC adaptor should be connected to a
vertically oriented or floor-mounted AC
outlet. Do not connect the AC adaptor to a
ceiling-mounted AC outlet, as the weight
of the adaptor may cause it to become
disconnected.
L The unit will not work during a power
failure. We therefore recommend you
also connect a corded-type telephone
(without AC adaptor) to the same
telephone line using a T-adaptor. Your
Hook
Panasonic sales shop can offer you more
information about connection possibilities.
Location
L For maximum distance and noise-free
operation, place your base unit:
– away from electrical appliances such as
– in a convenient, high and central
Battery
installation/replacement
Important:
L Use only the included rechargeable
batteries noted on page 4, 6.
L When replacing batteries, we recommend
(220–240 V,
using the Panasonic rechargeable
50 Hz)
batteries noted on page 5, 6.
1
TVs, radios, personal computers or
other phones.
location.
Press the notch on the handset cover
firmly and slide it in the direction of the
arrow.
L When replacing batteries, remove the
old batteries positive (S) terminal first.
Preparation
9
Hide quick links:
Advertisement
Table of Contents
