Panasonic KX-TG7100 Operating Instructions Manual page 35

TG7100-7120E(e).book Page 35 Tuesday, July 4, 2006 3:29 PM
Problem
The handset/base unit stops
working while being used.
Pressing {R} does not
display/dial the last number dialled.
The handset beeps intermittently
and/or 7 flashes.
I fully charged the batteries, but
7 still flashes.
Caller information is not displayed. L You must subscribe to Caller ID service.
While viewing caller information,
the display returns to standby
mode.
I cannot register a handset to the
base unit.
I cannot remember the PIN.
Helpline Tel. No.: U.K. 08700 100 076 R.O.I. 01289 8333
Cause & solution
L Disconnect the AC adaptor and turn off the
handset. Connect the AC adaptor, turn on the
handset and try again.
L The redialled number was more than 24 digits long.
Redial the number manually.
L Fully charge the batteries (page 10).
L Clean the charge contacts and charge again (page
10).
L It is time to replace the batteries (page 9).
L Your unit is connected to a telephone line with DSL
service. We recommend connecting a filter (contact
your DSL service provider) to the telephone line
between the base unit and the telephone line jack.
L Do not pause for over 1 minute while searching.
L The maximum number of handsets (6) are already
registered to the base unit. Cancel unused handset
registrations from the base unit (page 29).
L You entered the wrong PIN number. If you forget
your PIN, see "I cannot remember the PIN." (page
35).
L Place the handset and the base unit away from
other electrical appliances.
L Change the PIN using the following method.
1
{j/OK}
2
Press {^} or {V} to select "Base Unit
Setup". i {>}
3
"Other Options" i {>}
4
"Base Unit PIN" i {>}
5
Press {*}{7}{0}{0}{0}.
6
Enter the new 4-digit base unit PIN. i {>}
i {ih}
Useful Information
35