Multi-Unit Operation; Operating Additional Units; Registering A Handset To The Base Unit - Panasonic KX-TG7100 Operating Instructions Manual

TG7100-7120E(e).book Page 28 Tuesday, July 4, 2006 3:29 PM

Multi-unit Operation

Operating additional units

Additional handsets
Up to 6 handsets can be registered to the
base unit. Additional handsets will give you
the freedom to, for example, have an
intercom call with another handset while a
third handset is on an outside call. See page
5 for information on ordering additional
handsets.
Important:
L The additional handset model
recommended for use with this unit is
noted on page 5. If other model handset is
used, certain operations (handset
settings, base unit settings, etc.) may not
be available.
Registering a handset to
the base unit
The included handset and base unit are
preregistered. If for some reason the
handset is not registered to the base unit (for
example, w flashes even when the handset
is near the base unit), register the handset
manually (page 28).
To register an additional handset to the
base unit (easy registration)
After purchasing an additional handset,
register it to the base unit. Ensure that the
additional handset is switched on. If it is not
on, press and hold {ih} for few seconds
to turn the handset on.
1
Lift the additional handset and press
{ih} to put the handset in standby
mode.
2
Press and hold {x} on the base unit for
about 3 seconds, until the registration
tone sounds.
28 Helpline Tel. No.: U.K. 08700 100 076 R.O.I. 01289 8333
3
Place the additional handset on the
base unit. The registration tone
continues to sound. With the handset
still on the base unit, wait until a
confirmation tone sounds and w stops
flashing.
Note:
L If an error tone sounds, or if w is still
flashing, register the handset manually
(manual registration; page 28).
L If all registered handsets start ringing in
step 2, press {x} to stop. Start again from
step 1.
L Charge the batteries of your additional
handset for about 7 hours before initial
use.
L This registration method cannot be used
for handsets that have already been
registered to the base unit. Register the
handset manually (manual registration;
page 28).
To register a handset to the base unit
(manual registration)
You can register a handset to the base unit
manually using the following method.
1
{j/OK} i "Handset Setup" i
{>}
2
"Registration" i {>}
3
"Register H.set" i {>}
4
Press and hold {x} on the base unit for
about 3 seconds, until the registration
tone sounds.
L If all registered handsets start ringing,
press {x} to stop, then repeat this
step.
L After pressing {x}, the rest of this
procedure must be completed within 1
minute.
5
Wait until "Enter Base PIN" is
displayed, then enter the base unit PIN
(default: "0000"), then press {j/OK}.
L If you forget your PIN, see page 35.