Removing The Primary Hdd Module - Packard Bell EasyNote LJ77 Service Manual

Removing the Primary HDD Module

1. See "Removing the Lower Covers" on page 54.
2. Using the pull-tab, slide the HDD Module in the direction of the arrow to disconnect the interface.
3. Lift the HDD Module clear of the HDD bay.
NOTE: To prevent damage to device, avoid pressing down on it or placing heavy objects on top of it.
4. Remove the four screws (two each side) securing the hard disk to the carrier.
Step
HDD Carrier
60
Size
M3*3
Quantity
4
Screw Type
Chapter 3