Advertisement
_)TO
REPLACE
MOTION
DRIVE
BELT
BELT REMOVAL -
Engage parking brake (creates slack in belt).
•
Remove mower ddve belt from electric clutch pulley only
Roll motion ddve belt off transaxle pulley (1).
Roll belt off clutching idler pulleys (2), then off engine
pulley (3) and front V-idler pulley (4).
Pull belt out of all belt keepers (5).
BELT INSTALLATION
-
Place V part of belt into grooves on engine pulley and
front V-idler,
making sure to route belt inside of belt
keepers.
Put belt coming from V-idler above midspan belt keeper
(6), then onto clutching idler pulleys as shown.
Make sure V part of belt engages V-idler.
Place belt around transaxle pulley, beginning at top. V
part of belt should engage transaxle pulley.
•
P{ace long lower section of belt through loop in midspan
belt keeper,
Check to be sure belt is on proper side of all belt keepers.
•
Reinstall mower ddve belt onto electdc clutch pulley,
IMPORTANT:
CHECK
BRAKE ADJUSTMENT.
A.
Left side view
B.
Bottom view
1.
Transaxle
puUey
2.
Clutching idlerS
3.
Engine pulley
4.
V-idler
5.
Belt keeperS
6.
Midspan
belt keeper
6
A
2
B
63
Advertisement
