Belt Installation - Craftsman 917.271630 Owner's Manual

TO REPLACE MOWER BLADE DRIVE
BELT
Tl_e mowerblade drive belt may be
replacedwithouttools. Parkthe tractoron
level surface. Engage parkingbrake.
BELTREMOVAL-
1. Remove mowerfrom tractor(See "TO
REMOVE MOWER" in this sectionof
this manual).
2. Work belt off bothmandrel pulleysand
idler pulleys.
3. Pull belt away from mower.
BELTINSTALLATION-
4. Installnew belt in reverse order of
removal.
5. Make sure belt is in all pulley grooves
and inside all belt guides.
6. Installmower in reverse orderof
removal instructions.
Mandrel
Idler
Mandrel
Pulley
TO ADJUST BRAKE
Your tractor is equipped with an adjust-
able brake system which is mounted on
the right side of the transaxle.
If tractor requires more than six (6) feet
stopping distance at high speed in
highest gear, then brake must be ad-
justed.
1. Depress clutch/brake pedal and
engage parking brake.
2. Measure distance between brake
operating arm and nut "A" on brake
rod.
3. If distance is other than 1-1/2". loosen
jam nut and tum nut ",6."until distance
becomes 1-1/2". Retighten jam nut
against nut "A".
23
4. Road test tractor for proper stopping
distance as stated above. Readjust if
necessary. If stopping distance is still
greater than six (6) feet in highest
gear, further maintenance is neces-
sary. Contact a Sears or other
qualified service center.
With Parking Brake "Engaged"
Nut "A"
__ _ Nut
_ 3_OPmerating
TO REPLACE MOTION DRIVE BELT
Park the tractor on level surface. Engage
parking brake. For assistance, there is a
belt installation guide decal on bottom
side of left footrest.
1. Remove mower (See 'TO REMOVE
MOWER" in this section of this
manual.)
2. Remove belt from stationary idler and
clutching idler.
3. Pull belt slack toward rear of tractor.
Remove belt upwards from transaxle
pulley by deflecting belt keepers.
4. Pull belt toward front of tractor and
remove downwards from around
engine pulley.
5. Install new belt by reversing above
procedure.
EnginePulley--
Clutching Idlerj
tat onary der
Y
0