For The Installer - Caple C 5210 Instruction Manual

FOR THE INSTALLER

2 - Location
The cooker must be installed by a qualified technician and in compliance with
local safety standards.
This cookers has class "2/1" overheating protection so that it can be installed next to
a cabinet.
The furniture walls adjacent to the cooker must be made of material resistant to heat.
The veneered syntetical material and the glue used must be resistant to a temperature of
120°C in order to avoid ungluing or deformations.
If the cooker is installed adjacent to furniture which is higher than the gas hob cooktop, a
gap of at least 50 mm must be left between the side of the cooker and the furniture.
The cooker may be located in a kitchen, a kitchen/diner or bed-sitting room but not in a
room containing a bath or shower.
Curtains must not be fitted immediatly behind appliance or within 500 mm of the sides.
The cooker is equipped with a 4 levelling feet which must be fitted to the base of the
cooker.
It is essential that the cooker is positioned as stated below.
If the cooker is located on a pedestal it is necessary to provide safety measures to pre-
vent falling out.
Fig. 2.1
6