Wheel Removal; Jack Points - Honda HT4213 Owner's Manual

7. Wheel removal
l
Do riot attempt to remove a wheel unless the lawn tractor is on firm and
-
level ground.
l
Do not attempt to remove or replace a tire unless you have the equipment
and knowledge to do so properly.
Block wheels securely.
1. Remove the center cap and cotter pin.
2. Remove the wheel hub nut with .a 19 mm socket.
3. Raise the wheel off the floor using a jack and remove the wheel.
4. Apply a thin coat of grease to the wheel shaft splines before installing
the rear wheel. Install the washer with its "OUTSIDE" mark facing out.
Tighten the hub nut first to 5.5 kg-m (40 ft-lb) then continue tightening
it until one of the cutouts in the nut aligns with the hole in the shaft.
Install a new cotter pin on the shaft and bend it as shown.
[Jack points1
Front
CENTER CAP
WHEEL HUB NUT
FLAT WASHER