Honda HRA216 Owner's Manual
Honda HRA216 Owner's Manual

Honda HRA216 Owner's Manual

Honda lawn mower user manual

Advertisement

Advertisement

Table of Contents
loading

Summary of Contents for Honda HRA216

  • Page 3 This manual covers operation rotary mower. All information duct information available at the time of printing. Honda HRA216 mowers meet CPSC blade safety requirements behind rotary power mowers. Honda Motor Co., Ltd. reserves the right to make changes at any time without obligation.
  • Page 4: Table Of Contents

    CONTENTS CONTENTS 1. SAFETY INSTRUCTIONS 2. COMPONENT IDENTIFICATION 3. CONTROLS 4. PRE-OPERATION CHECKS ... 5. OPERATION Starting the Engine ... Mowing Flooded Engine ... Stopping the Engine ... High altitude operation Cutting Height Adjurstment Grass Bag ... 6. TRANSPORTING/STORAGE 7. MAINTENANCE 8.
  • Page 5: Safety Instructions

    Ewwl To ensure safe operation- Know how to stop the engine quickly the controls. Never permit anyone instruction. Do not allow children away from the area of operation. The rear shield is for your protection; The blade is sharp and dangerous. the mower.
  • Page 6 WARNING LABEL LOCATIONS...
  • Page 7 DANGER:KEEP HANDS and FEET AWAY ]]...
  • Page 8: Component Identification

    2. COlVlPONENT IDENTIFICATION DRIVE CLUTCH LEVER HANDLE 1 DISCH IARGE GUARD -----SHIFT LEVER CUTTING HEIGHT ADJUSTING LEVER (4PL1 SPARK PLUG CUTTER DECK...
  • Page 9 ROTO-STOP BUTTON ROTO-STOP LEVER THROTTLE LEVER RECOIL STARTER AIR CLEANER OIL FILI DRAIN BOLT...
  • Page 10: Controls

    3. CONTRO‘LS Throttle Control Lever Throttle positions: CHOKE STOP ROTO-STOP Lever To put the cutting blade into operation, ROTO-STOP lever and push the lever forward, handlebar. The blade will stop wheh the ROTO-STOP lever is released. CAUTION: To prevent that ROTO-STOP engagement/disengagement sharp movement of the lever.
  • Page 11 Drive Clutch Lever To propel the mower, against the handlebar. To propel the mower and operate the cutting blade simultaneously, the button on top of the ROTO-STOP lever and push the ROTO-STOP lever forward, then push the drive lever forward; the drive clutch lever will hold the ROTO-STOP lever forward, When the drive clutch releasing the drive clutch lever also releases the ROTO-STOP lever.
  • Page 12: Pre-Operation Checks

    4. PRE-OPERATION CHECKS 1. Check the engine oil level. CAUTION: Engine oil is a major factor Non-detergent and 2-stroke Running engine damage. Use Honda-4-stroke, motor oil certified to meet or exceed U.S. automobile quirements for service classification will show this designation SAE low-40 is recommended viscosity...
  • Page 13 2. Check the fuel level. Remove the fuel cap and the check the fuel level-. Refill the tank if the fuel level is low. Do not fill the fuel tank above the level mark. Your engine is designed to use any gasoline that has a pump octane ( ’...
  • Page 14 GASOLINES CONTAINING If you decide to use a gasoline containing tane rating is at least as high as that recommended two types of “gasohol”: methanol. Do not use gasohol that contains more than 10% ethanol. Do not use gasoline containing not also contain cosolvents use gasoline containing and corrosion inhibitors.
  • Page 15 3. Check the air cleaner. CAUTION: Never run the engine wear will result. 1. Check the air cleaner element to see if it is dirty. 2. If the element is dirty, follow the cleaning procedure described on page 29. WING NUTS AIR CLEANER COVER PAPER ELEMENT FOAM ELEMENT...
  • Page 16: Operation

    5. OPERATION Starting the Engine rmml Exhaust gas contains poisonous carbon monoxide. Never the mower in an enclosed area. Be sure to provide adequate ventilation. 1. Turn the fuel valve ON. 2. Move the throttle lever to CHOKE.
  • Page 17 3. Place your foot on the STEP of the mower housing. 4. Pull the starter grip lightly until you feel resistance, then pull briskly. CAUTION: Don’t allow Otherwise, the starting in operation, don’t pull the starter 5. After the engine warms up, move the throttle ROTO-STOP lever forward to put the cutting blade into operation.
  • Page 18: Mowing

    Mowing This MOWER should be used with the grass bag. The following suggestions Honda HRA216 under the safest conditions the same care using the mower as you would using any other power tool. Be especially careful may tilt, exposing blade.
  • Page 19 When mowing on a slope,cut vals) rather than up and down Be very careful when Do not use the mower Always set the gear shift lever in 1st while When mowing on an uneven engine speed, grip the mower’s across the slope (at equally changing the direction on a slope of more than20”.
  • Page 20: Flooded Engine

    Flooded Engine If the engine won’t start after several pulls on the starter rope, the engine may be flooded. To clear a flooded engine: 1. Move the throttle 2. Remove the spark plug and dry it. When reinstalling the plugs, thread it in by hand until it seats.
  • Page 21: High Altitude Operation

    High altitude operation At high altitude, the standard carburetor air-fuel mixture will be excessively rich. Performance will decrease, and fuel consumption High altitude performance main fuel jet in the carburetor and readjusting the pilot screw. If you always operate the rotary mower at altitudes level, have your authorized Honda Rotary Mower dealer perform these car- buretor modifications.
  • Page 22: Cutting Height Adjurstment

    Cutting Height Adjustment Five settings are available: 1. Stop the engine. 2. Push the front and rear adjusting them up or down to raise or lower cutting’ height. Adjust all four wheels to the same height. Be careful front wheel height.
  • Page 23: Grass Bag

    Grass Bag The bag is subject to wear under normal usage; check frequently ing and tears. Replace deteriorated bags or their equivalent. and make sure it is dry before using it. Clogged mesh will result in poor grass cutting quickly. Removal 1.
  • Page 24: Transporting/Storage

    6. TRANSPORTING/STORAGE Transporting Turn the fuel valve OFF when transporting the mower. c%ml To avoid fuel and oil spillage do not tilt the unit; spilled fuel may ignite. / FUEL VALVE 1. Remove the grass bag (p. 21). 2. Move the shift lever to the 2nd position.
  • Page 25 Loading CAUTION: To prevent loss of control use the drive system To prevent damage while the mower is rolling Transport the mower on the bed of the truck. Use a loading ramp unloading. Set the loading ramp so that its inclination To transport the mower, under the wheels.
  • Page 26 Preparation for Storage The following steps should be taken to protect the mower whenever it will be stored for longer than 30 days. 1. Drain the fuel tank and carburetor A. Disconnect the fuel line from the carburetor B. Loosen the carburetor C.
  • Page 27 3. Pull the starter grip until resistance is felt. This closes the valves and helps to protect the combustion 4. Coat areas that may rust with a light film of oil. Cover the mower and store it on a level surface in a dry, dust free area. Removal from Storage 1.
  • Page 28: Maintenance

    Honda parts parts which of the Honda HRA216 are essential if is to be maintained. Regular maintenance are described in the chart on the following keep the underside of the mower grass clippings by washing it down...
  • Page 29 Perform at every indicated operating Service more frequently when used in dusty areas, NOTE: Ill (21 These items should be serviced by an authorized lawn mower, unless the owner has the proper tools and is mechanically proficient. See the Honda Shop Manual.
  • Page 30 Engine Oil Change Drain the oil while the engine is still warm to assure rapid and complete draining. 1. Remove the filler cap. 2. Tilt the mower up onto- its right side and drain the oil from the filler opening. DlPhTlCK 3.
  • Page 31 Throttle Control Cable Adjustment 1. With the throttle lever in the CHOKE position, the carburetor choke arm should move all the way to the right as far as it will go. Push the choke arm with your finger to check whether it is all the way to the right. THROTTLE LEVER 2.
  • Page 32 Spark Plug Standard Plug: BPSES, BPR5ES (NGK) WI GEP-U, WI GEPR-U (ND) CAUTION: Use only Spark plugs which have an improper 1. Disconnect the cap and remove the spark plug. If the engine careful not to touch the muffler. 2. Visually inspect the plug. Discard the plug if it is heavily deposited or if the insulator is cracked or chipped.
  • Page 33 ROTO-STOP Lever Free Play 1. Measure free play at the tip of the lever with the button pushed down; it should be between 5-10 mm (3/16-3/8 in). 2. If adjustment is necessary, loosen the lock nuts and move the adjuster up or down as required.
  • Page 34 Spark Arrester Maintenance It is illegal in some areas to operate Check local laws and regulations rester is available from Honda If the mower has been running, cool before proceeding. 1. Remove the two 6 mm nuts and remove the muffler protector, tification plate, muffler and gasket.
  • Page 35 Blade Removal and Sharpening m!ml Wear heavy gloves Disconnect the spark plug cap to prevent 1. Turn the fuel valve OFF, and drain the carburetor 2. Tilt the mower so the carburetor side is up. Remove the blade bolts to remove the blade. NOTE: Never tilt the mower so the carburetor side is down, or hard start- ing will result.
  • Page 36 Carburetor Adjustment I, Start the engine and allow it to warm up to normal operating perature. 2. Place the throttle lever in the LO position. 3. Turn the pilot screw in or out to the setting that produces the highest idle rpm.
  • Page 37 Grass Bag Assembly 1. Insert the bag frame into the grass bag as shown. 2. Hook the plastic edges of the grass bag onto the frame.
  • Page 38: Troubleshooting

    TROUBLESHOOTING Engine will not start Hard starting or loss of power Erratic operation Engine overheats Excessive vibration 1. No fuel. 2. Throttle lever in STOP position. 3. Spark plug wire loose or disconnected. 4. Spark plug faulty or improperly gapped (p. 30). 5.
  • Page 39: Specifications

    565 x 1,035,mm (65.7 x 22.2 530 mm (20.9 l”-3.0” 53 kg (116.8 73 P II 9.3 US gal, 16.1 to change without notice. HRA216 MACR GXVI valve, 1 cylinder 20” BTDC magneto ignition US qt. 0.572 Imp qt) US gal, 0.44...
  • Page 40 10. WARRANTY Owner Satisfaction Your satisfaction and goodwill Honda warranty details are explained in the Distributor’s Normally, any problems concerning dealer’s service department. been handled to your satisfaction, action: Discuss your problem with a member of dealership management. complaints can be quickly already been reviewed with the Service Manager, contact the owner of the dealership or the General Manager.
  • Page 41 When you write or call, please provide the following information: • Model and serial numbers • Name of the dealer who sold the Honda power equipment to you • Name and address of the dealer who services your equipment •...

Table of Contents