Wheel Removal - Honda H4013 Owner's Manual

Wheel removal
Do not attempt to remove or replace a tire unless you have the equipment
and knowledge to do so properly.
1. Block the wheels securely.
2. Remove the wheel cap, and then remove the cotter pin and loosen the
19 mm nut one turn.
3. Jack up the front or rear of the lawn tractor, and place safety stands
under the frame. Remove the 19 mm nut, washer, and wheel.
4. Rear wheel only; apply a thin coat of grease to the rear axle (splined
position) before installing the rear wheel.
5. Install the wheel in the reverse order of removal.
6. Tighten the 19 mm nut to the lower specified torque.
Wheel nut torque: 5.5-6.5 kg-m (40-47 ft-lb)
7. Align the nut to the next possible cotter pin hole while tightening the
nut just beyond the lower specified torque. Install a new cotter pin and
bend the ends as shown.
NOTE: Do not align the cotter pin holes in a position where the wheel nut
torque is less than the specified torque.
[JACK POINTS]
Front
52
iEEL CAP
.