Table of Contents
Advertisement
AIR FILTER CLEANING
Remove and clean the air filters after every 25 hours of operation. Clean the
filters more frequently if operating conditions are very dusty. Clogged air filters
will cause the motor to overheat.
CAUTION: Overheating will damage the motor.
REMOVAL
1. Use a screwdriver to remove the
COVER SCREW (2) \
two screws from the motor cover,
then remove the cover.
2. Remove the two filters from the
cover.
CLEANING
1. Wash the filters in soapy water,
rinse, squeeze, and allow them to
dry thoroughly before installation.
2. Wash or wipe all dirt from the in-
side of the motor cover.
INSTALLATION
Install in the reverse order of re-
moval, using a screwdriver to se-
curely tighten the two cover screws.
When placing the motor cover on the
mower, be sure the power cord grom-
met is properly seated in the cover;
this grommet seals the cover to pre-
vent dust from entering.
CAUTION:
If dust enters, it will
shorten
the service
life of the
motor.
78
Advertisement
Table of Contents
