Installation - Alpine CDE-9827RR Owner's Manual

Installation

Caution
Do not block the unit's fan or heat sink, thus preventing air
circulation. If blocked, heat will accumulate inside the unit and
may cause a fire.
Air ventilation hole
(Rear side)
1
Bracket
Dashboard
Mounting sleeve
(Included)
No Pressure Here
No Pressure Here
Slide mounting sleeve from main unit (see
"Removal" on this page). Slide the mounting sleeve
into the dashboard and fix it with the metal
shackles.
2
Metal Mounting Strap
Hex Nut (M5)
When your vehicle has the Bracket, mount the long
hex bolt onto the rear panel of the CDE-9828RB/
CDE-9827R/CDE-9827RM/CDE-9827RR and put the
Rubber Cap on the hex bolt. If your vehicle does
not have the Mounting Support, reinforce the head
unit with the metal mounting strap (not supplied).
Connect all the leads of the CDE-9828RB/CDE-
9827R/CDE-9827RM/CDE-9827RR according to
details described in the CONNECTION section.
Rubber Cap
(Included)
Hex Bolt
(Included)
this unit
Screw
Bolt Stud
∗
this unit
• For the screw *, provide a proper screw to the chassis installing
location.
3
Slide the CDE-9828RB/CDE-9827R/CDE-9827RM/
CDE-9827RR into the dashboard. When the unit is
in place, make sure the locking pins are fully
seated in the down position. This can be done by
pressing firmly in on the unit while pushing the
locking pin down with a small screwdriver. This
ensures that the unit is properly locked and will not
accidentally come out from the dashboard. Install
the Detachable Front Panel.
Removal
1 Remove the detachable front panel.
2 Use a small screwdriver (or similar tool) to push the
locking pins to the "up" position (see above drawing).
As each pin is unlocked, gently pull out on the unit to
make sure it does not re-lock before unlocking the
second pin.
3 Pull the unit out, keeping it unlocked as you do so.
<JAPANESE CAR>
this unit
Lock pin
Front frame
Screws (M5 × 8)
(Included)
Mounting Bracket
23
-EN