Craftsman 315.115160 Operator's Manual page 21

POSmTmVE0 ° BEVEL STOP
See Figure 25.
The saw has a positive 0° bevel stop that has been factory
adjusted to assure 0 ° angle of the saw blade when making
90 ° cuts.
TO CHECK POSITIVE 0° BEVEL STOP
Follow these directions to check the positive 0 ° bevel
stop:
[] Remove battery pack from your trim saw.
_, WARNING: Failure to remove battery pack from
the tool could result in accidental starting causing
serious injury.
[] Place the saw in an upside down position on a work-
bench.
[] Check the squareness of the saw blade to the base of
the saw using a carpenter's square.
TO ADJUST POSITIVE 0 ° BEVEL STOP
Follow these directions to adjust the positive 0° bevel
stop:
[] Remove battery pack from your trim saw.
WARNING: Failure to remove battery pack from
the tool could result in accidental starting causing
serious injury.
[] Loosen bevel adjustment knob.
[] Turn setscrew with hex key and adjust base until it is
square with the saw blade.
[] Tighten bevel adjustment knob securely.
_. WARNING: Attempting a bevel cut without having
the bevel adjustment knob securely tightened can
result in serious injury.
REX NUT
PO81TIVE 0°
BEVEL STOP
BEVEL
ADJUSTMENT
KNOB
BLADE
Fig. 25
21