Craftsman 315.115160 Operator's Manual page 10

KNOW YOUR LASER TRiM SAW
See Figure 1.
Before attempting to use this product, familiarize yourself
with al! operating Features and Safety Rules
EDGE GUIDE
Edge guide is used when making long or wide rip cuts
with the saw.
SWITCH TRIGGER
The trim saw is equipped with a pre-travel safety switch
which reduces the possibility of accidental starting. When
you depress the switch, the saw will not start until you
reach the pre-travel position. You must depress the switch
fully to activate the saw.
BLADE WRENCH STORAGE
Convenient wrench storage for quick blade changes.
DEPTH CUT
Adjusts the depth of cut from 0 in. to 1-g/16 in.
SPINDLE LOCK
The spindle lock allows you to secure the blade when
turning the blade screw.
NOTE: Do not run trim saw with spindle lock engaged.
DUST CHUTE
To direct saw dust and chips away from the operator,
a dust chute is located on the side of the upper blade
guard.
ERGONOMJC DESIGN
The design of your trim saw provides for maintaining
proper two hand control when cutting. Hthas been de-
signed to be comfortable and easy to grasp.
LASER GUIDE
The laser guide will generate a red colored line on the
work surface when turned on.
UNPACKING
This product requires assembly.
[] Carefully remove the tool and accessories from the
box. Make sure that aJ!items listed in the packing list
are included.
[] hspect the tool carefully to make sure no breakage or
damage occurred during shipping.
[] Do not discard the packing material until you have
carefully inspected and satisfactorily operated the tool.
[] Hfany parts are damaged or missing, please call
1=800-932=3188 for assistance.
PACKING UST
Cordless Trim Saw with Laser
5-1/2 in. (140 mm) Blade
Battery Pack
Laser Batteries
Charger
Edge Guide
Blade Wrench
Operator's Manual
WARNING: Hf a ny parts are missing do not operate
the tool until the missing parts are replaced. Failure
to do so could result in possible serious personal
injury.
WARNING: Do not attempt to modify this tool
or create accessories not recommended for use
with this toot. Any such alteration or modification is
misuse and could result in a hazardous condition
leading to possible serious personal injury.
WARNING: To prevent accidental starting that
could cause serious personal injury, always remove
the battery pack from the tool when assembling
parts.
REMOVING BATTERY PACK
See Figure 2.
[] Locate latches on side of battery pack and depress to
release battery pack from your saw.
[] Remove battery pack from your saw.
TO
REMOVE
DEPBE88LATCHESTO
RELEASE BATTERYPACK
TO LATCHES
JN$TALL
BATTERY PACK
Fig. 2
10