Deep Sanitizing Instructions; General Use & Maintenance; Maintenance; Replacing The Hard Water Filter - Oreck Grab It & Steam It User Manual

Operation
continued
General Use
&

Maintenance

E
For Deep Sanitizing Clean
Allow unit to heat for one minute.
1
Set the steam selection button to HIGH STEAM.
2
Use short scrubbing motions on hard floor area for at least 15 seconds.
3
Cleaning Surfaces / Suggested Steam Settings
Grout on Hard Surfaces
1
Tiled Surfaces
2
Sealed Hardwood
3
Maintenance
When you have finished steam cleaning, ensure both of the Grab-It & Steam-It's power switches
1
are turned off and that the plug is removed from the wall.
Empty the remaining water from the water tank.
2
Microfiber steam mop pads can be machine washed at 140 F maximum. For heavily soiled
3
pads soak in warm water with detergent or a mild stain remover. Allow cloths to dry
completely before storing. NOTE: DO NOT USE FABRIC SOFTENER

Replacing the Hard Water Filter

The hard water filter will help filter
minerals that reduce the effectiveness
of the steam cleaner. Depending
on hard water conditions and/or use
frequency, the filter should be replaced
every 6 months.
WARNING: Unplug cord from electrical outlet before servicing.

Brushroll Maintenance

At least once a month, check for and remove excessive lint, string or hair from the revolving
brushroll.
Brushroll
: Rotate screw 1/4 turn until the indicator is aligned with the "unlock" symbol.
IMPORTANT
A little preventative maintenance will keep your Sweep and Steam looking new and will ensure
continued cleaning effectiveness.
Replacing the Brushroll
The brushroll is designed for long life. Should it ever become worn or frayed, it can be replaced
by an Oreck Authorized Service Center.
9
N G L I S H
Medium to High
Low to Medium
Low
The condition of the hard
Hard Water Filter
water filter affects the
performance of the steam
cleaner. The interval
between filter replacement
depends on the hard water
conditions and the level
of usage.
Indicator
Lock
Unlock
NOTICE