2-year warranty. Simply install the handle and you are ready to enjoy your new Oreck Grab-It & Steam-It Power Broom & Steam Mop. ™ Welcome to our Call. Click. customer service program. To speak with an Oreck representative call or click using the information below. Call USA: 1•800•989 • 3535 Canada: 1•888•676•7325...
Safety General Warnings IMPORTANT SAFETY INSTRUCTIONS! When using an electrical appliance, basic precautions should always be followed, including the following: READ ALL INSTRUCTIONS BEFORE USING THIS APPLIANCE WARNING!: To reduce the risk of fire, electric shock, or injury: • Do not leave appliance unattended when plugged in. Unplug from outlet when not in use and before servicing.
Operation Parts List 1 Cord dump 2 Water Tank Release Lever 3 Water Tank 4 Replaceable Hard Water Filter 5 Lift Out Debris Cup 6 Steam Activation Trigger 7 Power Broom ON/Off Switch 8 Steam Heating/ Steam Ready/ Sweep On Indicator Lights 9 Steam On Button/ Steam Level Adjustment Dial...
Port on the back of the Grab-It & Steam-It™ handle. Leave excess cord at the power head to allow movement. Operating the Oreck Grab-It & Steam-It ™ Up-Position Lock - Place foot on power head and lean handle back gently to release lock for use.
Operation Power Broom Operation: continued Press the “SWEEP ON/OFF” button to activate the brush roll. NOTE: The power broom can operate on hard floors with or without the steam mop pad holder attached. NOTE: Remove steam mop pad holder when using on low pile carpeting. To empty the debris cup grasp the cup handle and lift out.
Operation Steam Mop Operation: continued Align and attach Velcro on the microfiber steam mop pad to the Velcro on the microfiber ® ® steam mop pad holder. To attach the Grab-It & Steam-It’s microfiber steam mop pad holder, place foot on release pedal and gently push down, lower the power head onto the microfiber steam mop pad holder and LIGHTLY press down to snap into place.
Operation continued Steam Mop Operation: continued Press the “STEAM” button. The “STEAM HEATING” light will come on. Rotate the steam selection button to choose the optimal steam level, right for higher, left for lower. (Refer to page 9 for suggested settings) When the “STEAM READY”...
A little preventative maintenance will keep your Sweep and Steam looking new and will ensure continued cleaning effectiveness. Replacing the Brushroll The brushroll is designed for long life. Should it ever become worn or frayed, it can be replaced by an Oreck Authorized Service Center.
• The brushroll is set up with a brushroll motor to keep turning while the brushroll is clutch. stopped. A clicking noise can be heard still does not • Contact Oreck Authorized Service Center. • Check all the above points. Steamer operate properly. Parts All accessories and replacement parts are sold separately.
Oreck or an Oreck Authorized Retail Dealer.) Oreck will repair or replace, free of charge, to the original purchaser, any part that is found to be defective in material or workmanship within two (2) years of the date of purchase. This limited warranty applies to normal domestic use.