Moving The Wet/Dry Vac; Blowing Feature - Craftsman 113.177895 Owner's Manual

Operation (continued)
Moving the Wet/Dry Vac
To maneuver the Vac, the metal handle in
the rear of the unit should be positioned
in the upright position for ease of
movement. Be sure to unlock the back
wheels by pulling up on the wheel locks
before moving the Vac.
Blowing Feature
Your Vac features a blowing port. It can
blow sawdust and other debris. Follow the
steps below to use your Vac as a blower.
1. Locate blowing port of your Vac.
_k WARNING: Always wear safety
eyewear complying with ANSI Z87.1
(or in Canada, CSA Z94.3) before
using as a blower.
,4k WARNING: To reduce the risk of
injury to bystanders, keep them clear
of blowing debris.
,/k CAUTION: Wear a dust mask if
blowing creates dust which might be
inhaled.
Ak CAUTION: To reduce the risk of
hearing damage, wear ear protectors
when using the Vac/Blower for
extended time or in a noisy area.
2. Insert the locking end of the hose
assembly into the blowing port of the
Vac. The hose should snap into place.
To remove the hose from the Vac,
press the release button in the hose
assembly and pull the hose out of the
Vac inlet.
3. (Optional) Attach extension handle to
opposite end of hose, then place the
crevice tool on the wand.
4. Turn Vac on and you are ready to use
' Pull Up to Unlock
Wheel Locks
your Vac as a blower.
Craftsman recommended accessories are
available at Sears retail stores and
www.Sears.com. The Sears Blower
Nozzle Stock No. 16933 is recommended
for blowing debris.
12