Advertisement
RULES FOR SAFE OPERATION
The following safety precautions are suggested. This
broadcast spreader is designed, engineered and tested
to offer reasonably safe and effective service, provided it
is operated in strict accordance
with these instructions.
Failure to do so may result in personal injury. Always
observe the rules of safe operation.
1. Do not allow anyone to operate the spreader without
proper instructions.
2. Do not permit children to operate the spreader.
3. Wear eye and hand protection when handling and
when applying lawn or garden chemicals.
4. Read the labe! instructions and cautions for handling
and applying the chemicals purchased for spreading.
5. Keep all nuts, bolts and screws tight to be sure
equipment is in safe working condition.
6. Follow maintenance
and lubrication instructions as
outlined in this manual.
FLOW CONTROL LEVER _.______
ADJUSTABLE
STOP
1)
ADJUSTING
THE FLOW RATE SETTING
1. Loosen the wing nut that fastens the control to the
handle.
2. Slide the Adjustable stop to the desired setting and
retighten the wing nut.
HOW TO USE YOUR SPREADER
1. Pivot the handle up into the operating position and
tighten the two wing nuts.
2. This unit will cover a 4 to 8 foot wide area depending
on the material used and walking the speed of user.
3. Check the listing on the material package or in the
Recommended
Spreader Settings instruction sheet
for the proper spreader setting and application rate.
4. Before filling the spreader, push the control lever to
the "OFF" position.
5. Move spreader onto a flat surface - either a walk or a
driveway - and fil!.
6
Slide the Adjustable Stop to the desired setting.
7. Start the spreader in motion, then move the control
lever forward against the adjustable stop to begin
spreading.
NOTE: Always place control lever in the "OFF" position
while filling spreader and when stopping or turning to
prevent excess fertilizer from being released.
APPLICATION
TIPS
1. To avoid misses or striping, make each pass about
5 feet from the previous one so some overlapping of
spread pattern does occur.
2. For easiest application, spread across the shortest
edges of lawn first, making two "header" strips for a
turning area, and then spreading between the header
strips. See figure 1.
3. If lawn is odd shaped, spread a border around the
edges and then spread between the border. See
figure 2.
4. Keep wheel approximately 4 feet from any area you
do not wish to spread.
IMPORTANT:
Be careful when using spreader around
ornamental plants because weed controls can damage
these plants.
f
FIGURE 1
_IGURE 2
1. Always empty spreader after each use, storing
leftover material in it's original bag.
2. Wash the spreader and dry thoroughly after each use.
3. Apply a few drops of oi! to all moving parts.
4. Tighten al! nuts and screws before each use.
Advertisement
