Operation - Craftsman 315.274050 Owner's Manual

_h,
WARNING: Always remove battery pack from your
saw when you are assembling parts, making
adjustments, assembling or removing blades,
cleaning, or when not in use. Removing battery pack
wi_ prevent accidenta_ starting that could cause
serious personal injury.
TO REMOVE BATTERY PACK
See Figure 3.
• Locate latches on end of battery pack and depress to
release battery pack from your saw.
/ t
BATTERY PORT
LATCHES
DEPRESS LATCHES
TO RELEASE
BATTERYPACK
L.
BATTERY PACK Fig. 3
• Remove battery pack from your saw.
TO INSTALL BATTERY PACK
See Figure 3.
• Place battery pack in your saw. Align raised rib inside
saw with groove on battery pack.
• Make sure the latches on each side of your battery
pack snap in place and battery pack is sec_ed in saw
before beginning operation.
_1, CAUTION: When placing battery pack in your saw,
be sure raised rib inside saw aligns with groove on
battery pack and latches snap in place properly.
Improper assembly of battery pack can cause
damage to internal components.
TO INSTALL SAW BLADE
See Figure 4.
• Remove battery packSee Figure 3.
WARNING: Failure to remove battery pack from
saw could result in accidental starting causing
possible serious personal injury.
BLADE BLADE CLAMP
CLAMP SCREW
HOLEIN
PIN SAW BLADE
SAW BAR BLADE CLAMP
BLADE
CLAMP SCREW
BLADE
CLAMP HOLE
ALLEN WRENCH BLADE
Fig. 4
• Remove the 5 mm Allen wrench provided with your
saw from Allen wrench holder. Note: Allen wrench
holder is located in bottom portion of saw handle.
See Figure 1.
• Loosen the blade clamp screw enough to permit the
saw b_ade to be inserted between b_ade c_amp and
saw bar.
Note: It is never necessary to remove the blade clamp
screw from the blade clamp when installing or
removing blade.
• Align the hole in the shank of the blade and blade
clamp with the pin in the saw bar, then seat both on
the pin in the saw bar.
• Tighten blade clamp screw securely.
• Remove Allen wrench and store it in Allen wrench
holder.
• Replace battery pack.
10