Accessories - Craftsman 315.274050 Owner's Manual

Blade Stroke 1-3/16 in. No Load Speed 0-2500 SPM
Motor 18 Volt DC Switch Variable Speed
Charger Rating 120 Volts, 60 Hz, AC only Shank Capacity 1/2 in.
Charger Rate 1 Hour
Your reciprocating saw has been shipped completely
assembled except for the b_ade. Inspect it carefully to
make sure no breakage or damage has occurred during
shipping. If any parts are damaged or missing, contact
your nearest Sears Retail Store to obtain replacement
parts before attempting to operate saw. Two blades and
this owner's manual are also included.
,_ WARNING: If any parts are missing, do not operate
your saw until the missing parts are replaced. Failure
to do so could result in possible serious personal
injury.
The following recommended accessories are currently available at Sears Retail Stores.
BLADE TYPES
LENGTH
IN.
For fast smooth cuts in woods, masonite, plastics, hard composition
board and all plunge cutting. Keyhole blade shape permits cutting in
hard to reach areas.
Forfast, smooth, deep cutsthroughthick wood, plastic, composition
board, and hardboard.
For rough cuts in wood.
High speed steel blade for cutting ferrous metals less than 1/8 in. thick
and for cutting tubing or pipe with a 1/8 in. thick wall section or less.
TEETH
PER IN.
6
12 6
6 14
4 24
_1= WARNING: The use of attachments or accessories not listed above might be hazardous.
BLADE SELECTION
To obtain the best performance from your saw it is important to select a specific blade for the particular application and
type of material you wish to cut. By doing this you will get a smoother faster cut and prolong blade life. Replacement
blades for this saw are available from your nearest Sears Retail Store.