How To Charge; Assembly - Craftsman evolv 320.30854 Operator's Manual

HOW TO CHARGE THE BATTERY PACK (Fig. 2)
Detach the battery pack from the drill/driver.
Insert the power unit jack into
charging socket, making sure
they are properly connected.
Power unit can be used with
normal house voltage of 120
volts, 60 Hz, AC only.
Connect the plug of power unit to
an electrical outlet. The indicator
light on the battery pack shines
red when the power unit is
plugged into a power source.
Charge the battery for at least 7
hours before the first use.
For best use, do not recharge the
battery for less than 5 hours or
more than 7 hours after each use.
Fig. 2
Charging sock
Charging indicator
Do not place the power unit in an area of extreme heat or cold. It works best at
normal room temperature.
The base of battery or power unit may become warm during charging. This
is normal.
TO ATTACH BATTERY PACK (Fig. 3)
1. Lock the trigger switch on
the drill/driver by placing the
direction-of-rotation (forward/
center-lock/reverse) selector
in the center position.
2. Align the raised ribs on
the battery pack with the
grooves on the bottom of the
drill/driver, and then slide the
battery pack onto the base
of the drill/driver.
Fig. 3
Battery pack
Attach release button
NOTICE: When placing the
battery pack on the tool, be sure
that the raised rib on the battery
pack aligns with the groove on
the drill/driver and the latches snap into place properly. Improper assembly of
the battery pack can cause damage to internal components.
30854 Manual Revised 11-0616 Page 14