Advertisement
LIFT ARM/TURNBUCKLE
ASSEMBI-Y
Figure 8. ,_
L
28. Assemble the first Pivot Bracket(4) with the
short leg towards the =enter of the Tractor
Drawbar and to the far left Side using two 5/16"
x 1" Hex Bolts(12), Lock Washers(19) and Hex
Nuts(15) "13ghten securely.
Figure 9.
29. Place LiftArm Assembly(31) inside hole of Pivot
Bracket(4) as shown in Ftg 9. Note that that
longer arm on the Pivot Brad_t will be to the
right or more towards the center of the tractor.
30 Assemble the other Pivot Brasket(4) with short
leg facing towards the left side of the Drawbar
using two 5/16" x 1" Hex Bolts(12), Lock
Washers(19) end Hex Nuts(15). "13ghten
securely.
31. ConneCt previously assembled Lift Bar
Assembly(2B) to short arm on Ltit Arm
Assembly(31) using ',_"diameter x 1-114"Clevis
Pin(3), Plain Washer(21 ), and small Retaining
Spring(9).
32.Thread a 5/8" Hex Jam Nut(18) onto the longer
right hand threaded Lower L.iff Link(6), as far as
possible.
33 Assemble Lower Lift LinkAseambly(6-step 32)
into the right hand threaded end of S_.eve
Adjustment Link('/')as far as possible.
34. Thread the shorter, (left hand threaded)
upper
Lift Link(5) into other end of Sleeve Adjustment
Link(7)(screws in counter-clockwiea) as far as
possible.
35 Atl_ch the completed Tumbu_le Assembly to
the upper adjusting hole in the LiftArm
Assembly(31) and the welded tab in Hitch Ball
Assembly(29), Secure each end with a small
Retaining Spring(9). 11ghtanthe Jam Nut(18)
against Sleeve Adjustz1_entLink(7)_
36, Make sure all Bolts and Nuts previously
assembled are tight,
F
Figure 8.
Assemble in Step 2g.
LEFT S/DE V/EW
9, L-1874_R.0O
Advertisement
