Advertisement
LIFT BAR AND EXTENSION
STRAPS
Figure 6.
NOTE: Extension Straps(30) are used WIUl
Me_anical
LiftTm_ors(havinglift handles) only
and wit_not be used when mounting to Tm_
using Electric LiftAccsesodse.
CMECHANICAL LIFT TRACTORS
22.,_ssemble the two Extension Straps(30) to the
Lift Bar Asesmbly(28) using two 3/8'_( %1/4"
He:<Bolts(14), Lock Washers(20), end Hex
Nu_s(16).
NOTE:, Make sure the holes in the opposite end
of Straps ere in line, then tighten securely.
Figure 7. )
23.From RIGHT side of Tractor, locate the T_u_tor
Lift Shaft Assembly under the Tractor Frame.
24. Position the Lift Bar Assembly(28), with
Extenston Straps(3g), along inskta of Tractor
Frame with welded end towards rear of Tractor,
Stide welded end through cutout in upper left
side of Omk_ar as shown.
25. Position Extension Straps(30) over Tractor Lift
Shaft Assembly Arm(at LEFT side of Tractor),
aligning end holes to Straps(30) with bottom
hole in Lift Arm. Secure using 3/8"x %1/8"
Clevis Pin(24), and Small Retaining Spring(g).
(.,ELECTRIC LIFT TRACTORS
)
NOTE: This mounting will not require the use of
Extension Straps(30),
26, Position the Lift Bar Assembly along inside of
Tractor Frame with welded end towards the rear
of Tractor. Slide welded end through cutout in
the upper left side of Drawber as shown.
27.NOT SHOWNI: .P|e-se refer to the Electric L|ft
Manual if needed,
Postion and of Uft BarAssembly(28) between
opening of Electric Lift double straps, Align
holes and secure using 3/8"x 1,-t/8" Clevis
Pin(24) and Small Retaining Spring(g).
,, ,,
,,, •
f
Figure 6.
..
)
Figure
Tractor Lift S haft Assembly
\
.J
Advertisement
