Advertisement
FRONTFRAME&
LIFT ASSEMBLY
Figure I,_
BEFORE PROCEEDINGlU
1. Mower Deck must be removed from Tractor.
2. Tractor HeightAdjustment Knob must be
lowered completely.
far as possible (see Fig. 1).
3. Lower the Lift Mechanism completely
(Mechanical or Electric).
4. Remove Plastic Accoss Cover (part # 121749X)
from the Left Side of Tractor Frame.(see Fig. 3)
5. Remove the Hex Bolt securing the top of the
Tractor Fuel Tank Bracket to the frame on the
left.hand side,
6. Install the Lift Assist Bracket(23) over the fuel
tank]orecket as shown. TheUltAss/stBrackat
assembles to the outside of the frame, with the
short/eg through the opening/n frame. Secure
using two 3/8°_xl" Hex Bolts(13-MUST BE
INSTALLED FROM INSIDE TO OUTSIDE),
Lock Washara(20), Hex Nuts(16), and a 3/8"
Washer(26) between the the Lift Assist Bracket
and the fuel tank bracket in the FORWARD
HOLE ONLY1 "r'_jhtenSecurely.
7. Make sure the fuel tank Hex Bolt previously
removed is tightened securely,
8. From the rear of the tremor, feed the LiftAssist
Spring(27- hook end first) along the inside left of
the Tractor frame, just below the fuel tank.
9. Locate the Tractor Lift Shaft Assembly.
! 0, Insert the the "hook-end" of the LiftAssist
Spring(27) into the 'T'-shaped hole in the Lift
Shaft Assembly as shown.
NOTE: LlftAssist Spring(27) and Bolt can be
easily accessed through Access opening at left
sicle of Tractor. Simply remove cover on frame
to access if not already removed from Step 4,
1I. As shown, secure the Lift Assist Spring(27) in
the top-right of the "T"-shaped hole using a
3/8"x1" Can'iage Bolt(11), 3/8" Washer(26),
Lock Washer(2g), and Hex Nut(16),
Figure I.
r
I
I
.1
TRACTOR REARENDWEW
Rguro 2. ,,)
©
DETAIL
&
Advertisement
