GE GTS18DBPFLCC Owner's Manual And Installation Instructions page 20

Installation Instructions
REVERSING THE DOOR SWING (CONT.)
[] TRANSFER BOTTOM HINGE
BRACKET TO THE LEFT
Remove the base grille by grasping it about 6" from
each end and pulling its bottom edge toward you.
Using a Torx ®driver, move the bottom hinge bracket
and plastic washer from the right side to the left side.
NOTE: lfthe washer is not on the hinge bracket,
check to see if it is stuck to the bottom of the doon
HingeBracke
Before replacing the base grille, remove the grille
cap by removing the screw. Screw the cap to the
opposite side.
Replace the base grille by inserting the tops of the
metal clips into the owal vents, making sure one of the
plastic tabs on the back of the grille goes into each of
the oven vents. Then push the bottom of the grille
forward until it snaps into place.
[] TRANSFER CENTER HINGE
BRACKET TO THE LEFT
Remove the center hinge bracket by removing the
three Torx ®screws.
NOTE: Keep these screws with the hinge bracket.
They are long .screws and will be used when installing
the hinge on the other side.
On .some models, you will need to remove the color-
matched caps from the screw heads before you can
remove the screws. Use the edge of a thin fiat blade to
gently pry the caps off the screw heads. (A putty knife
works well for this.) Cover the blade with tape to
prevent scratching the paint.
Remove the three Torx ®screws from the center lef}
side of the cabinet. Screw them into the holes on
the right side.
Place the center hinge bracket over the holes at
the center left side of the cabinet, lnsert and
tighten the three long screws.
Replace the caps by snapping them over the screws
with your fingm:
\
[] TRANSFER DOOR STOPS
On each doo_, move the metal door stop from the
right to the left.
Move any screws from the left to the right.
DoorSto
LeftSide RightSide
20