Installing The Blade - Craftsman 113.247440 Owner's Manual

INSTALLING THE BLADE
t Loosen the upper blade guide assembly and
lower to approximately 3 inches above rear table
and retighten lock knob This is necessary to
make adjustments to blade guide and back up
roller bearing
LOCK KNOB
2 Remove the blade guard by loosening the two (2)
mounting screws with a phillips screwdriver and
lifting the blade guard upward,
_,DE GUARD
MOUNTING
SCREW
-BLADE GUARD
MOUNTING
SCREW
= == i IN, m=, =,IHH,,II,,,, I ==l,= ==l "
3, Loosen the two capscrews that lock the upperBLADE GUIDECAPSCREWS __/
blade guides using a 1/8-inch hex "L" wrench
and separate them about 1/8-inch, Repeat the
same step for the lower blade guides
BLADE GUIDE
CAPSCREWS
4 Loosen the setscrew which locks the blade guide
support and push the support all the way back
Repeat for lower blade guide support
GUPu_(_BE BuLp ADE
[]PORT L,.___
SETSCREW
__..__,______...__,.._zJl_ _
LOWER
BLADE
IGUIDE SUPPORT
, _ _ J SET SCREW
19