Features - GE GXSH39E Owner's Manual & Installation Instructions

ge.com
Normal Operation, Control Displays
During normal operation, the present time of
dQy Qnd AM or PH and DAYSTO EMPTY show
in the control displQy QreQ.When the demand
computer determines a rechQrge is needed,
RECHARGETONIGHT begins to flQsh in the
display along with the present time. RECHARGE
TONIGHT flashes until the next rechQrge start
time, then chQnges to RECHARGE,which flQshes
until the rechQrge is over.
Feature: Optional Recharge Controls
Sometimes, a manuQIly started rechQrge may
be desired or needed. Two exomples:
You hove used more water thQn usuQI (house
guests, extra washing, etc.) and you may run
out of soft water before the next rechQrge.
The system ran out of sQIt.
Use one of the following feQtures to start a
rechQrge immediQtely, or at the next preset
rechQrge start time.
RECHARGE TONIGHT
Touch (do not hold) the RECHARGE_ button.
RECHARGETONIGHTflQshes in the control
displQy areQ. A rechQrge will occur at the next
preset recharge start time. If you decide to cancel
this recharge, touch the same button once more.
RECHARGE
Press and hold the RECHARGE@ button until
RECHARGEstarts to flash in the control display
area. The water softening system begins an
immediate recharge and, when over in about two
hours, you will have a new supply of soft water.
Once started, you cannot cancel this recharge.
Feature: Memory
If electrical power to the water softening system
is interrupted, the control display is blank, and
the blue indicator light is off, but the control
keeps correct time for about 6 hours. When
power is restored, you have to reset the present
time only if the display and blue indicator light
are flashing. All other settings are maintained
and never require resetting unless a change is
desired.
If the time is flashing after a long power outage,
the water softening system continues to work as
it should to provide you with soft water. However,
recharge may occur at the wrong time of day
until you reset the control to the correct time
of day.
Feature/Service: Automatic Electronic Diagnostics
The control computer has a self-diagnostic
function for the electrical system (except input
power and water meter). The computer monitors
the electronic components and circuits for
correct operation. If a malfunction occurs,
an error code appears in the control display.
The chart on Error Codes shows the error
codes that could appear and possible reasons
for each code. See Monuo!ly Initioted Electronics
Diognostics to further isolate the defect.
17