Features - GE GNSF48A01 Installation And Owner's Manual

RECHARGE TONIGHT
TOUCH
or
RECHARGE NOW
HOLD
Normal Operation, Timer Display
During normal operation, the present time of day and AM or PM show in the control
display area. When the demand computer determines a regeneration is needed, RECHARGE
TONIGHT begins to flash in the display along with the present time. RECHARGE TONIGHT
flashes until the next regeneration start time, then changes to RECHARGE NOW, which
flashes until the regeneration is over. The display also shows the current cycle in the
regeneration process. When the valve is in transition between cycles, both indicators flash.
Feature: Optional Recharge Controls
Sometimes, a manually started regeneration (recharge) may be desired or needed.
Two examples:
You have used more water than usual (house guests, extra washing, etc.) and you may
run out of soft water before the next regeneration.
You did not refill the storage tank with salt before it was all gone.
Use one of the following features to start a regeneration immediately, or at the next preset
regeneration start time.
RECHARGE NOW
Press and hold the TOUCH or HOLD button until RECHARGE NOW starts to flash in the control
display area. The water softening system begins an immediate regeneration and, when over
in about two hours, you will have a new supply of soft water. Once started, you cannot
cancel this regeneration.
RECHARGE TONIGHT
Touch (do not hold) the TOUCH or HOLD button. RECHARGE TONIGHT flashes in the control
display area. A regeneration will occur at the next preset regeneration start time. If you
decide to cancel this regeneration, touch the same button once more.
Feature: Program Memory
If electrical power to the water softening system is interrupted, the control display is blank,
but the control keeps correct time for about 72 hours. When power is restored, you have to
reset the present time only if the display is flashing. All other settings are maintained and
never require resetting unless a change is desired.
If the time is flashing after a long power outage, the water softening system continues to
work as it should to provide you with soft water. However, regenerations may occur at the
wrong time of day until you reset the control to the correct time of day.
15