Table of Contents
Advertisement
MOUNT SAWONWORK SURFACE (FIG.C)
1. Ifthelegsetwillnotbeused,thesawmustbe
properly secured toa sturdyworkbench u sing the
fourmounting holes at thebaseofthesaw.
2. Thesurface ofthetablewhere thesawis tobe
mounted m usthavea holelarge enough tofacilitate
sawdust %Fthrough a ndremoval
& Square thesawonthemounting surface andmark
thelocation ofthefour3/8in.mounting holes (1).
4. Drill 3 /8in.holeintothe mounting s urface.
& Mark an 11in.square (2)centered between thefour
mounting h oles(1).
& Cutoutandremove thesquare.
7. Thisopening willallowsawdust t ofal!through the
sawbase.
& Place thesawontheworksurface, a ndalignthe
mounting h olesofthesawwiththosedrilled through
thesurface.
9. Fasten thesawtotheworksurface.
IA WARNING
I
Do not operate this machine on the floor. This is
very dangerous
and may cause serious
injury.
Fig. C
IA WARNING
I
Failure to provide the sawdust fall-through
hole for
use of the saw when mounted to a work surface and
not the stand will cause sawdust
to build up in the
motor area, which may result in fire or cause motor
damage.
IA WARNING
I
Always keep your work area clean, uncluttered and
well lit.
INSTALLING
THE DUST BAG (FIG. D)
[_
WARNING]
Do not use this saw to cut and/or sand metals. The
hot chips or sparks may ignite sawdust
or the bag
material
Place the dust bag around the neck of the dust
chute and tie the dust bag pulling the string tight
and secure with the spring4oaded
tie clip.
Fig. D
BLADE RNSJNG HANDWHEEL
(FIG. E, F)
1. Attach the up .- down handwheel (1) to the elevation
rod (2) at the front of the saw. Make sure the slots (3)
in the hub of the handwhee! (1) engage with the
pins (4).
2. Attach and tighten the dome nut (5 - Fig. F).
Fig. E
BLADE TILTING HANDWHEEL
(FIG. F)
1. Attach the bevel 0 ° .- 45 ° handwheel (6) to the blade
tilting rod on the right side of the saw in the same
manner as above.
2. Attach and tighten the handwhee! dome nut (5).
Fig. F
11
Hide quick links:
Advertisement
Table of Contents
