Remote Control Description; On/Off - Frigidaire FRS124YW10 Use & Care Manual

Remote control description
ON/OFF: Press this button to start
the unit operation. Push the button
again to stop the unit operation.
MODE: Each time you press the
button, a mode is selected in a
sequence that goes from AUTO,
COOL, DRY, FAN ,and HEAT*, as
the following figure indicates:
(oo/[rl_ mid he_ltin_ mode]
* Note: Only for models with heating
function
+ : Press the button to increase
the indoor temperature setting.
re:Press the button to decrease
the indoor temperature setting.
@
FAN :This button is used
for setting Fan Speed in the
sequence that goes from AUTO,
,-,,,1 to ._J| , then back to
Auto.
r Aulo -------_ --------_ _ J -------_ _ dllJJ]
Low fan ..,tJ Middle fan .,_j J High fan
5| :Press this button, to set up swing
angle and swing range,which
circularly changes as below:
, J
oFF _ gl _--_J ÷ _inl
_,|whch
re&cares the hozlzontal louver
" will swing up and down automatically,
@
TIMER ON: Pressthis button to
initiate the auto-on timer.To cancelthe
auto-timer program, simply press this
button again.
@
@
TIMER OFF: Press this button to
initiate the auto-off timer. To cancel
the auto-timer program,sinply press the
button again.
CLOCK: Pressthis button, the clock can
be set up, icon _ blinks. Within 5
seconds, the value can be adjusted by
pressing "+" or "-" button, if continuously
press this button for 2 seconds above,
in every 1/2 seconds, one minute will be
increased, if you are still pressing the
button after ten minutes increased,ten
minutes will be increased every 1/2
seconds. Druing blinking, repress the
Clock button, icon _ will be constantly
displayed and it denotes the setting
succeeded