Door Removal; Cool Down Period; Temperature Control - Frigidaire PLRU1778ES4 Use & Care Manual

LEVELING
The refrigerator must have all bottom corners resting firmly on a
solid floor. The floor must be strong enough to support a fully
loaded refrigerator. NOTE: It is Very Important for your
refrigerator to be level in order to function properly. If the
refrigerator is not leveled
_packing and Leveling
during installation, the
door may be misaligned
and not close or seal / i!_. T°_4_R_
properly, causing
cooling, frost, or moisture
problems.
Leveling Fue,
To Level Refrigerator: c,_,,,_
After discarding crating
screws and wood base,
use a carpenter's level to
level the refrigerator from
front-to-back. Adjust the
plastic leveling feet in
front, Vz bubble higher, so 4/c,_Ln_s .....
And {2) Wood Bases
that the door closes -._
easily when left halfway Unpacking andLeveling
open.
Leveling Instructions for all Refrigerator/Freezer Pair:
,, Remove two leg levelers provided in literature bag. While
unit is lying on its back for wood skid removal, install both
leg levelers in rear of unit.
,, Level door of first unit using all four levelers and slide unit
into place. Recheck for levelness and adjust if necessary.
,, Measure distance from floor to bottom of door on first unit.
Adjust and level second unit so door height matches.
,, Leg Level Adjustments
,, One full turn of all four leg levelers will raise door 5/32".
®
®
,, One full turn
3/16" and tilt
,, One full turn
1/32" and tilt
,, One full turn
of both front leg levelers will raise door
top of door back 7/16".
of both rear leg levelers will lower door
top of door forward 7/16".
of both side leg levelers will raise door
3/16" and tilt top of door 3/8".
Slide second unit into place leaving a minimum gap of 3/16"
between units for door swing clearance.
This last step may require at least one extraction of the
second unit to properly align units in a "built-in" application.
......... Shelf Front
DOOR REMOVAL
If door must be removed :
1. Gently lay refrigerator on its back, on a rug or blanket.
2. Remove two base screws and base panel.
3. Remove bottom hinge screws.
4. Remove plastic top hinge cover.
8. Remove screws from top hinge.
6. Remove top hinge from cabinet.
7. Remove door and bottom hinge from cabinet.
8. To replace door, reverse the above order and securely
tighten all screws to prevent hinge slippage.
Glass Cantilever Shelving
['_ . _ _ //Dairy Door
,,ghtO°ckL'tshield ....
DDre'iwer I
Mid Level I
Humidity _/
Control Temperature Control
Two Liter
Door Bins
.Fixed Gallon
Door Bins
COOL DOWN PERIOD
For safe food storage, allow 4 hours for the refrigerator to
cool down completely. The refrigerator will run continuously
for the first several hours.
TEMPERATURE CONTROL
The temperature control is located inside the refrigerator
compartment. The temperature is factory _-_...
preset to provide satisfactory food storage f 2 _
temperatures. However, the temperature / _j_"_. \
control is adjustable to provide a range of [ _' ,,;;_ 1
temperatures for your personal satisfaction. I _ ."- ]
If a colder temperature is desired, turn the
temperature control knob toward COLDEST _ _
and allow several hours for temperatures to
stabilize between adjustments. Cold Control