Air Direction - Frigidaire FRA106HT10 Use & Care Manual

VENTILATION CONTROL
The ventilation control lever is located at left side of
unit, behind the front panel.
NOTE; The vent door shipping screw must be
removed before using vent control lever. See
Installation Instructions.
When set at CLOSE, only the air inside the room is
circulated and filtered.
When set at OPEN, outdoor air will be drawn
into room.
Energy Tip; Keep the vent control at CLOSE. Room
air will be filtered and circulated.
Vent Control
(Pull lever through label
to operate,)
Fig. 13 - Ventilation Control Location
ADJUSTING AIR DIRECTION FOR DUCTED INSTALLATIONS ONLY
To adjust air direction;
1. Remove front panel. See Fig. 10.
2. Remove louver screws that hold louver insert in place (from back side of front panel). See Fig. 14.
3. Turn louver insert and rotate 180 ° . See Fig. 18.
4. Replace louver insert.
5. Replace screws and front panel.
NOTE; Upward air direction should only be used on ducted installations.
Louver screws
Louver screws
Fig. 14 - Backside of Front Panel
Air discharge upward
Air discharge outward (Default)
i
Fig. 15 - Adjusting Louvers
© 2010 Electrolux Home Products, Inc. All rights reserved.