Frigidaire FRA106HT10 Use & Care Manual page 6

RETROFIT SLEEVE PREPARATION
IMPORTANT: Inspect wall sleeve thoroughly prior to installation, Manufacturer does not
assume responsibility for costs or damages due to defects in sleeve or for improper installation,
ELECTRICAL SHOCK HAZARD
Failure to follow this warning could result in personal injury or death.
Disconnect all power to unit to avoid possible electrical shock during
installation.
Remove any existing foam baffles that are installed on competitive outdoor grille, if present. See Fig. 4.
GE Sleeves Only
GE MetaI WalI Sleeve - GE metal sleeve is interchangeable with Frigidaire wall sleeve. See Fig. 5.
GE Plastic Sleeve - Remove bottom seal from plastic sleeve. See Fig. 6.
INSTALLATION OF A FRIGIDAIRE WALL
SLEEVE USING A NON- FRIGIDAIRE GRILLE
Using a Frigidaire wall sleeve with a non-Frigidaire grille requires installation of an Accessory Baffle Kit
(see Fig. 7), which ensures a good seal between the unit and exterior grille to prevent air recirculation. Air
recirculation is a large contributor to performance loss and premature damage to major components.
Notes: Frigidaire stamped grille is interchangeable with GE'S.
J
BAFFLES
Fig.4-Remove Existing Outdoor Grille
Baffles on Competitive Grille
SLEEVE
Fig.5-GE Metal Sleeve
BOTTOM SEAL
Fig. 6 - Remove Bottom Seal From GE Plastic Sleeve Fig. 7-Accessory Baffle Kit
Note: Contact your units supplier to get the kitr the actual baffle
kit may look different from the image shown above.
© 2010 Electrolux Home Products, Inc. All rights reserved.