Attach Hose Reel - Craftsman 580.752090 Operator's Manual

Attach Hose Reel
You wiii need the foiiowing tools to assemble the hose reel:
o 8 mm (5/16")wrench
o Phiiiips screwdriver
1, Place hose reeI onto Ieft side of handle (A) (viewing from
handle side of unit) just above carriage bolt. Make sure
pin (B)in hose reel clamp inserts in hole (C) on handle,
I
NOTE:Make sure hose reel is attached to the handle facing
the engine,
2, Close hose reeI ciamp (A) and insert "T" bolt (B),
Tighten by hand,
.
Remove shipping cap from fitting on hose reet and
attach one end of shorter high pressure hose to hose
reel fitting. Tighten by hand,
.
Remove shipping cap from pump. Attach other end of
shorter high pressure hose to high pressure outlet on
pump. Tighten by hand.
Uncoil high pressure hose and slide metal reinforced end
(A) through hole of hose reel.
6, Attach high pressure hose to fitting on hose reel. Tigilten
by hand.
7. Slide hose damp (A) onto high pressure hose. Using an
8 mm wrench and a phiiiips screwdriver, attach hose
clamp to hose reei with screw (B) and lock nut (C).
8. PulI ring on pin and rotate to vertical position to lock pin
open.
9, Puff hose reel handte outward and coil higil pressure
hose onto hose reei,
10, Line up pin with hote in hose reei and puii ring on pin,
Rotateto horizonta! position and let ring slide into
groove to lock hose reel in place,