Advertisement
Available languages
Available languages
Customer Responsibilities
Before
Daily
each
or after
each
Jse
use
3heck Safety Valve
•
Drain Tank
•
_Bisk
of Unsafe
Operation. Unit
cycles automatically
when power
is on. When servicing,
you may
be exposed
to voltage sources,
compressed
air, or moving parts.
Before servicing
unit unplug or
disconnect
electrical
supply to
the air compressor,
bleed tank
of pressure, and allow the air
compressor
to cool.
NOTE: See Operation section for the
location of controls.
To Check
Safety
Valve
_Bisk
of Bursting.
If the safety valve
does not work properly, over-
pressurization
may occur, causing
air tank rupture
or an explosion.
1.
Before starting compressor, pull
the ring on the safety valve to
make sure that the safety valve
operates freely. If the valve
is stuck or does not operate
smoothly, it must be replaced
with the same type of valve.
To Drain Tank
1.
Set the On/Auto/Off
lever to
"OFF" and unplug unit.
2.
Pull the regulator knob out and
turn counterclockwise
to set the
outlet pressure to zero.
3.
Remove the air tool or accessory.
4.
Pull ring on safety valve allowing
air to bleed from the tank until
tank pressure is approximately
20 psi. Release safety valve ring.
5.
Drain water from air tank by
opening drain valve (counter-
clockwise) on bottom of tank.
_Biek
of Bursting.
Water will
condense
in the air tank. if not
drained,
water will corrode
and
weaken
the air tank causing
a risk
of air tank rupture.
6.
After the water has been drained,
close the drain valve (clockwise).
The air compressor can now be
stored.
NOTE: If drain valve is plugged,
release all air pressure.
The valve
can then be removed, cleaned, the
reinstalled.
15-ENG
N000317
Advertisement
