Advertisement
Available languages
Available languages
Become familiar with these terms before operating the unit.
CFM:
Cubic feet per minute.
SCFM:
Standard cubic feet per minute; a unit of measure of air delivery.
PSIG:
Pounds per square inch gauge; a unit of measure of pressure.
Code Certification:
Products that bear one or more of the following marks: UL,
CUL, ETL, CETL, have been evaluated by OSHA certified independent
safety
laboratories and meet the applicable Underwriters
Laboratories
Standards for
Safety.
Cut-In Pressure:
While the motor is off, air tank pressure drops as you
continue to use your accessory. When the tank pressure drops to a certain low
level the motor will restart automatically.
The low pressure at which the motor
automatically
restarts is called "cut-in" pressure.
Cut-Out
Pressure:
When an air compressor
is turned on and begins to run,
air pressure in the air tank begins to build.
It builds to a certain high pressure
before the motor automatically
shuts off, protecting your air tank from pressure
higher than its capacity.
The high pressure at which the motor shuts off is
called "cut-out"
pressure.
Branch Circuit:
Circuit carrying electricity from electrical panel to outlet.
This unit is capable of powering the following Accessories.
The accessories
are
available through the current Power and Hand Tool Catalog or full-line Sears
stores.
Accessories
•
In Line Filter
Tire Air Chuck
Quick Connector
Sets (various
sizes)
Air Pressure Regulators
Oil Fog Lubricators
Air Hose: 1/4", 3/8" or 1/2" I.D. in
various lengths
Refer to the selection chart located
on the unit to select the tools this unit
is capable of powering.
This air compressor
pump is capable of running continuously.
However, to
prolong the life of your air compressor, it is recommended
that a 50%-75%
average duty cycle be maintained; that is, the air compressor
pump should not
run more than 30-45 minutes in any given hour.
9-ENG
N000317
Advertisement
