Operation; Charging Your Screwdriver; To Charge; Collet - Craftsman 973.111380 Owner's Manual

01/17/o2 THU 11:53 FAX 864 964 3314 RyOBI CUSTOMER SERVICE _oo8/o12
Failure to do so could result in objects being thrown
into your eyes, resulting in possible serious injury.
CI'_ARGINGYOUR SCREWDRIVER
This tool has been shipped in a low charge condition to
prevent possible problems. Therefore, you should charge it
ovmnlght prior to use.
NoI_= Batteries will not reach full charge the first time they
are charged Allow several cycles (driving screws followed
by recharging) for them to become fully charged.
If _e charger does not charge your screwdriver under
normal droJmstances, return both the screwdriver and
cha_er to your nearest Sears Service Center for ele_deel
dmdk.
TO CHARGE "
• _sert dlarger plug Int0 input jack making sure they •
are properly connected,
III Charger can be usod wRh normal household
lq)ltsge of 120 volts, 60 Hz, AC only.
• Connect chargerto power supply.
II A_P.rnormal usage, 8 minimum of 10 hours of charg-
ing time is required to be fully charged.
• Do not place charger In an area of extreme heat or
mid. It will work best at normal room t_mperatore.
COMET
The miler on your screwdriver has been designed to accept
114in. hex bits. See Figure 3.
TO INSERT BIT
Sea F_urs 3.
bit into collet as far as possible.
N_e: One bit is packed with your screwdriver.
CHARGER
CHARGER PLUG
INPUT
Fig. 2
COLLET
Fig. 3
7