Table of Contents
Advertisement
OPERATING
THE SAW (Fig.12)
It is important
to understand
the
correct
method for operating
the
saw. Refer to the instructions
in
this section to learn the correct
and incorrect
ways for handling
the saw.
_,
WARNING:
To make sawing
easier and safer, always maintain
proper control of the saw. Loss of
control could cause an accident
resulting
in serious injury.
Fig. 12
guideline
Line of cut
0° indicator
,_
WARNING:
Always securely clamp and support the workpiece.
Always
maintain proper control of the saw. Failure to clamp and support the workpiece
and loss of control of the saw could result in serious injury.
INTEGRATED
CROSSCUT
RULERS
Marked along the base across the front of the saw is a ruler for measuring
repetitive
cuts. It is marked 1-1/2 inches to the left of O°and 4 inches to the right
of O°in 1/16 inch increments.
NOTICE: The distance
from the line of cut to the guideline
is the amount you
should offset the guide (Fig. 12).
31024Manual
Revised 11-0629
Page21
Advertisement
Table of Contents
