Fisher & Paykel DD24 Series User Manual page 31

Continuous Afault h as o ccurred. Refer tothe'Fault codes' section.
beeping
Intermittent DishDrawe¢ _isinpause Close the DishDrawe¢ _ and press theHt
beeping mode. button.
Power supply isnot Connect the power supply.
connected.
The drawer isnot c losed Ensure thedrawer isfirmly c losed.
DishDrawe¢ _will
not start
is on. down the _/@ button until the@ symbol
disappears from the LCD screen or the light
above thee/@ button disappears,
blt button not pressed, Press the HI button,
Excess water in the Drain hose(s) bent or Straighten the drain hose{s).
DisbDrawer _ kinked.
Blocked filters, Clean the filter plate/drain filter. Refer to the
'User maintenance instructions' section,
Water marks on the Rinse agent depReted. RefiR[the rinse agent dispenser.
dishes Rinse agent setting too low. Increase the rinse agent setting.
DishDraweP _ overloaded/ Refer to the section on loading.
incorrectly loaded.
Insufficient or no salt in the Ensure there is enough salt in the water
water softener (DD24-oH softener and/or increase the water
models only), softener setting.
DishDrawe¢ _ Some foods, like tomato Pre-dnse dishes before placing in the
interior is stained based products, may DishDrawePL Alternatively, using the Rinse
stain the inside of the program after adding the dishes may
DishDrawePL minimize staining.
Dishes did not dry Incorrect loading. Ensure the dishes are not nesting together.
Rinse agent depleted. Refill the rinse agent dispenser.
Rinse agent setting too low. Increase the rinse agent setting.
Eco wash program used_ Choose a standard wash program_
No detergent Detergent dispenser was Clean the dispenser and ensure the
dispensed wet when Ioaded_ dispenser is dry when adding detergent_
Excessive motor The filter plate and/or spray Refer to the'User maintenance instructions'
noise arm is incorrectly placed, section for details on correct placement.
No water in the motor area. This usually occurs on the first use or when
the DishDraweP _ has not been used for
long periods of time, Run the DishDraweP _
through a wash program,